Rule Rule-Mate 1500 GPH Fully Automated Bilge Pump - 12V

Rule-Mate 1500 GPH 12 Volt Fully Automated Bilge Pump

The Rule-Mate® 1500 GPH pump consists of a powerful Rule® bilge pump and a highly intelligent circuit board in a single housing. The pump activated when the water reaches 2-1/2" and automatically shuts off when the pump senses no water against the impeller, reducing the remaining water to approximately 5/8".

Rule-Mate Intelligence
Rule-Mate Bilge pumps have built-in programming that can sense when the pump is running but not pumping water. This is a very unique feature to bilge pumps because it protects the pump and the vessel, especially the vessels batteries. If debris fouls the sensor or the pump becomes air-bound, the pump will stop running and begin to "check" for water every 2-1/2 minutes. Once the debris is removed, the pump will revert to its normal operation, turning on when the water reaches 2-1/2" and shutting off at 5/8".

• 1500 GPH (6819 LPH) at 0' (13.6V)
  
• All-in-one pump and switch
  
• Extra long life heavy duty motor
  
• 1" NPS discharge with 1" AND 1 1/8" screw-on ports
  
• Three year warranty

WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.

 

Additional Specs (If Applicable):

• Volts = 12v
• Operation = Automatic
• Gallons Per Minute = 25 GPM
• Gallons Per Hour = 1500 GPH
• Type = Electric